User Manual

Camera parts and controls 23
4.5 Power supply
The camera power is supplied by external power sources only. It accepts an input
voltage range from 10.5 to 34 V DC. Do not supply power outside the specified
voltage range.
NOTICE
If the power supply is interrupted with the camera switched on, the camera will
automatically repower and boot-up on reconnection.
Always keep the BAT connector accessible so that the cable can be unplugged
quickly in case of emergency.
Use the 8-pin LEMO connector and a KC50-S or KC50-SP-S ca-
ble to supply the camera with 10.5 to 34 V DC. Do not use cables
longer than 4m.
4.6 Camera Controls
The controls of the camera are explained in this chapter.
4.6.1 Function button FN and camera buttons 1-3
RECREC
1
2
The left camera side is equipped with the function button FN (1) and three buttons
labelled 1 through 3 and additional icons (2), which can act as regular user buttons or
perform common camera functions in combination with the function button.
Camera buttons as user buttons:
By default, the camera buttons 1 to 3 function as user buttons.
For information on how to assign functions to user buttons, see "Assigning
functions to camera user buttons", page 133.
Whenever the assigned function is active, the blue LED of the user button is lit.