User Manual

Physical Installation

WARNING! Attach an approved safety-cable to

secure the product against clamp or bracket failure.

Lead the safety-cable through the stirrup and keep it

as short as possible. The safety-cable needs to be

approved at least 10 times the weight of the product

including all accessories mounted at the product.

Secure all accessories mounted at the product with

additional safety-cables to protect them from fall

down and cause injuries and damages.

WARNING! The rigging structure needs to be

approved for at least 10 times the weight of all

devices, equipment and cables installed on it.

WARNING! The stirrup must be mounted hanging or

standing vertically. Lateral load can cause deforma-

tion or breaking of the spigot and the stirrup.

CAUTION! Block access below the work area and

work from a stable platform whenever installing, ser-

vicing or moving the product or accessories.

IMPORTANT! Do not illuminate the display and the

fresnel-lens by high power light beams from a short

distance. The display and the light engine are dam-

aged by high brightness and heat radiation within

very short time.

To adjust the stirrup

You need

• a Torx20 screw driver,

• a 10 mm allen key and

• a torque wrench (37 ft-lbs)

to adjust the stirrup.

On delivery the stirrup is in the basic position (tilted back).

Loosen the Torx20 screws on both sides of the stirrup bracket

slightly and pull the stirrup bracket towards the rear of the pro-

duct. Loosen the lever of the tilt-lock and tilt the stirrup

upwards.

Slide the stirrup to the point of balance. The point of balance is

dependent on the accessories mounted at the product. Tighten

both Torx20 screws of the stirrup brackets. Do not overtighten

the screws. Tilt the stirrup to the desired position and tighten

the tilt-lock by using the lever. For better leverage, press the

knob on the tilt-lock-lever and turn the lever to the desired po-

sition.

To mount the spigot

Place the spigot and the distance plate on the 13 mm hole in

the middle of the stirrup. Insert the allen screw with washer and

spring washer and tighten it with a torque wrench to 37 ft-lbs

torque.