User Manual

Fixture Menu
22
To set the Signal lost behavior
Set the signal lost behavior:
• Press the + / [up] or - / [down] button, until SETUP is displayed
left in the display.
• Confirm with the ENTER button. Press the + / [up] or - / [down]
button until DMX is displayed.
• Confirm with the ENTER button. Press the + / [up] or - / [down]
button until LSIG is displayed.
• Confirm with the ENTER button. The current setting is
displayed.
The following options are available:
• HOLD: The last received DMX values are used until the L7 is
switched off or valid DMX data is received again.
• BOUT: The L7 douses to 0% intensity.
• H2MF: The last received DMX values are used for 2 minutes.
After 2 minutes the L7 douses to 0% intensity. When valid
DMX data is received after less than 2 minutes, these data will
be used.
• Press the + / [up] or - / [down] button to select the signal lost
behavior. Confirm the selected mode with the ENTER button.
The option blinks three times for confirmation.
• Press the FUNCT button to leave the menu.
To set the DMX mode
Set the DMX mode using the fixture menu:
• Press the + / [up] or - / [down] button, until SETUP is displayed
left in the display.
• Confirm with the ENTER button. Press the + / [up] or - / [down]
button until DMX is displayed.
• Confirm with the ENTER button. Press the + / [up] or - / [down]
button until PROT is displayed.
• Confirm with the ENTER button. The current DMX mode is
displayed.
• Press the + / [up] or - / [down] button to select the DMX mode.
Confirm the selected mode with the ENTER button. The DMX
mode blinks three times for confirmation.
• Press the FUNCT button to leave the menu.
To set the display illumination and status indicators
To switch the display illumination and status indicators on or
off:
• Press the + / [up] or - / [down] button, until SETUP is displayed
left in the display.
• Confirm with the ENTER button. Press the + / [up] or - / [down]
button until INDC is displayed.
• Confirm with the ENTER button. The current setting is
displayed.