User manual

Arnold & Richter Cine Technik GmbH & Co. Betriebs KG, Pulvermühle, 83071 Stephanskirchen

www.arri.com

5.1.12 Error messages

Code Error Solution

E.003 Controller over temperature Let the lamphead cool down. After that the status LED should light up

Green again. The lamphead is available for operation.

Set the fader to 0 and then set the desired value.

E.004 Light Engine over temperature See solution for E.003

E.005 Power supply over temperature See solution for E.003

E.006 Calibration data faulty or read error of

light engine memory

NOTICE: Loss of calibration data can only be solved

in the factory. (You might have to exchange the light engine

and carry out calibration again.)

E.007 Invalid PWM value calculation This merely serves as a notiﬁ cation that a fault has occurred during

calculation.

E.008 Invalid values during calculating step 1 See solution for E.007

E.009 Invalid values during calculating step 2 See solution for E.007

E.010 Fan error. Exeeding deviation from

pre-set speed or fan outage. This error

can only be detected in fans with speed

indicator (3 wire fan).

CAUTION: Only a trained service person is allowed to ﬁ x this error!

Set the fan to LOW or HI and see if it starts rotating, in order to determi-

ne if there is an electrical malfunction.

All mechanical tests or repairs may only be carried out by a trained ser-

vice technician.

From SW version 1.72.0

E.011 On-board control could not be detected,

or on-board control ID has not been pro-

grammed at the lamphead.

If the on-board control is working, error E.011 can be ignored. However,

if the on-board control remains dark (no LED lights up) we recommend

contacting a service partner. They can then carry out detailled analyses.

E.012 Temperature sensor(s) are defective or

deviation within NTC values too high.

One or more temperature sensores are defective or the deviation within

the individual NTCs or BNTCs exceeds the variation tolerance of 54° F.

Check the error log (LSeries Manager) to see which temperature senso-

res are affected. Ask your service partner to ﬁ x this error.

ENGLISCH