User manual

Arnold & Richter Cine Technik GmbH & Co. Betriebs KG, Pulvermühle, 83071 Stephanskirchen

www.arri.com

Manufacturer commands

Command (English) Description GET SET

RDM Fan Mode

PID:0x8001

Changes the FAN mode of the ﬁ xture

- this message supports Set and Get commands

- the ﬁ rst data byte is used to show / change the fan mode

USER_FAN_MODE_OFF = 0

USER_FAN_MODE_LOW = 1

USER_FAN_MODE_HIGH = 2

USER_FAN_MODE_AUTO_LOW = 3

USER_FAN_MODE_AUTO_HIGH = 4

RDM Status LED

PID:0x8002

Switch on /off indication LEDs and LCD back light

- this message supports Set and Get commands

- the ﬁ rst data byte is used to switch indication LEDs on and off

LEDs and LCD back light on = 0

LEDs and LCD back light off = 1

Supported from SW-Version 1.72.0, only L7-T4

RDM L7T4CH CCT

ADJ

PID:0x8003

CCT value, the CCT value can be used to do some settings manu-

ally

yes yes

Supported values from 2600K - 10000K, only L7-T4

RDM L7T4CH GN ADJ

PID:0x8004

GN value, the GN value can be used to do some settings manually yes yes

Supported values from -1 to +1

RDM DMX Signal Lost

Mode

PID:0x8005

If the DMX signal gets lost or the DMX device is unplugged the

LED ﬁ xture holds the last valid signal, or it holds the last valid sig-

nal for two minutes and then dimms or switches off immediately.

Supported values:

0 -> hold

1 -> hold 2 minutes

3 -> switch off

yes yes

ENGLISCH