User manual

Arnold & Richter Cine Technik GmbH & Co. Betriebs KG, Pulvermühle, 83071 Stephanskirchen

www.arri.com

5.3.7 Firmware Update

Carry out the steps in the following order:

- Choose the folder to which you have extracted the ﬁ rmware version. This is necessary if you have downloaded a

single ﬁ rmware version (not available yet) or the intermediate update.

- The LSeries Manager automatically checks the installed version on your lamphead for a possible update.

(If your version is lower than 1.65 you have to press “Check L7 for possible updates”). Please do not change any settings

here, unless you have been asked to do so by an ARRI technician.

Please check your currently installed ﬁ rmware! If the bootloaders are lower than version 2.0 you have to install an intermediate

update (this should occur only in versions lower than 1.65). After you have installed the intermediate update, you can upgrade to all

newer versions. This update is included in all bundle version of the LSeries Manager in the folder „L7_Bootloaders_V2“.

Note: If your lamphead does not contain an on-board control panel you do not have to select the position „Control Panel“ !

ENGLISCH