User Guide

To use a power supply

Battery Pack on Caster Stirrup

The battery pack can be directly attached to the stirrup:

• The battery pack is attached to the stirrup by pushing it into

the stirrup vertically. Make sure the pins on both sides of the

battery pack snap into the slots in the T-shaped components

of the stirrup.

• To remove the battery pack, simply pull the knob on top of the

battery pack.

To use a power supply

To use the LoCaster with power supply, please do the

following:

• Connect the POWER IN plug of the LoCaster with the XLR-4

connector of the power supply 24 V= / 60 W using a XLR-4

cable.

• Connect the correct power cable to the power supply unit.

• Plug the mains connector into a mains socket nearby.

Note: You can also use the power supply 24V= / 300 W to

power the LoCaster. Obey all information regarding the power

supply given on page 12. In this case the DMX functionality of

the BroadCaster power

supply is not used.