User Guide
To power the BroadCaster
23
• Gently press both sides together to close the suppressor ele-
ment.
• To open push the key in the two holes in the suppressor ele-
ment until the element opens.
To use the power supply
When powering the BroadCaster, make sure the product
receives a valid DMX512 signal in addition to a correct input
voltage (PowerDMX). Therefore using the DMX512 capable
power supply unit 24V= / 300 W is recommended.
• Connect a DMX512-capable control device via a XLR-5 cable
to the DMX IN of the power supply.
• Connect the BroadCaster via XLR-4 cables to the PowerDMX
outputs of the power supply. Obey all information regarding
the power supply given on page 12.
• To connect more than one BroadCaster unit to one
PowerDMX output, use the PowerDMX OUT on the
BroadCaster to daisy-chain the signal to another BroadCaster
via a XLR-4 cable.
• Connect the correct power cable to the power supply unit.
• Plug the mains connector into a mains socket nearby.
• Switch on the power supply unit. The ON/OFF switch is
illuminated when the unit is powered.