User Guide

To power the BroadCaster

Notes: Do not overload the outputs of the power supply.

To loop through the incoming DMX signal to other devices

(e.g. to other power supplies), please use the DMX output on

the backside of the power supply unit.

Make sure the ventilation openings in the housing are

never covered while using the product.

Disconnect the unit from mains before connecting the

products.

Always make sure the XLR connectors snap in with a

clearly audible click sound. Otherwise the connec-

tions may loosen while using the system.

You can use the BroadCaster with the power supply unit

24 V= / 60 W. However there will be no DMX functionality

available. Only the backup modes of the BroadCaster will be

available.

Make sure to only connect a single LED panel when

using the power supply unit 24 V= / 60 W. To daisy

chain the input voltage to another device is not per-

mitted.