User Guide

Safety Information
7
Specific Safety Information
Intensive use can cause the surface and the heat sink
to become hot. Let the product cool down complete
before you handle it.
Never cover air vents and the heat sink
during operation.
Never point a light beam from another product into
the light source. Do not place the product on heat
sources. Intense heat causes automatic power off
during operation.
Devices and accessories must be secured against fall
when mounted above floor level. Always observe
common and local safety regulations.
Never use the cables for transportation. Never hang
the product on its cables. Do not hang a battery pack
on its connection cable to the product.
CAUTION: High voltage! Always disconnect the
product complete from mains voltage before you
connect or disconnect a cable or replace the fuse of
the product.
CAUTION! High voltage! Never try to open the power
supply. Replace defective power cables. Do not use
the product with defective power cables.
Only use the ARRI Caster power supply products
described in this manual. Never use other power
supply products as this products can be damaged or
damage the connected products.
Never bypass any fuse.
Always keep cables away from the product during
operation.
Disconnect all cables prior to transport.
CAUTION! High intensity light beam! Never look
direct into the light beam!
Not to observe these safety information or to ignore common
sense may cause serious injury or even death. Damage to the
product or other devices is possible.