Instruction manual

12
13
4. Setup
Switch off the camera and disconnect all cables
from the camera and the FEM-2 before installing
the FEM-2 on the camera.
Switch off the camera and disconnect all
cables from the camera and the FEM-2 before
installing the URM-1 on the camera.
The installation of the FEM-2 and the URM-1 has
to be carried out on a static free workstation.
Preparation
• Verify the software version of the camera before
installation:
Software version 3.xx or higher is required to
operate the FEM-2 with the
ARRIFLEX 435 Advanced.
• A 3mm Allen key is required to install the FEM-2 on
the camera.
• A 2.5mm Allen key is required to install the URM-1
on the FEM-2.
Installation and Setup