Instruction manual

4.1 Installing the FEM-2 on the camera

Install the FEM-2 on the right side of the camera.

Installation must be carried out at an ESD-

secured workstation.

To install the device:

• The camera should be xed ideally on a pivoting

head to secure working.

• Turn the camera off and disconnect all cables.

• Remove the screw on the FEM-1 that is installed on

the right side of the camera photo.

• Pull the FEM-1 backwards to remove it from the camera.

• Take the FEM-2 out of its packaging.

• Insert the two tabs at the front of the FEM-2 into the

guiding on the camera (or IVS) photo.

• Press the FEM-2 into the connectors on the camera.

• Secure the FEM-2 using the screw supplied

(tightening torque< 0.5Nm)

Installation and Setup