Instruction manual

22
23
To change the radio channel:
• With the camera off, set the channel and then turn
the camera on.
• Set the channel selection switch to 9 (deactivated)
and then turn it to the required channel within half
a second.
• Set the channel selection switch on the activated
camera to the new channel, the RF LED goes red.
Then turn the camera off and back on
after around 5 seconds.
The RDY LED of the radio system photo indicates
the status of the radio as follows:
Color Status
Off wireless remote control deactivated (channel 9 selected)
or camera deactivated
or camera has no power
alternating radio modem is being initialized.
red/green Do not activate WMU-1 yet.
Green blinking wireless remote control is ready, activate the WMU-1.
Green wireless remote control OK
Red channel selection switch has been changed.
Wireless remote control will continue to function
but the channel will be changed the next time it is
switched on.
-> Reset to the previously selected channel
if the change was unintentional, or turn module off
and on again to change channel.
Red blinking hardware error in radio module.
If this error still occurs even after restarting the camera,
replace the radio module or send the FEM-2 and radio
module for service.
Red blinking rapidly Radio fault: another URM, LDB or FEM-2
are on the same channel. Select another channel.
Operating