Instruction manual
24
25
• Use the direction switch to change the rotational
direction of the attached motor.
The status LED indicates the following:
The following pages show some of the possible setups
with the LCS system. These are only samples and further
variations are of course possible.
The LC-M1, LC-M2, LC-Z1 and LC-Z2 cables are inter-
changeable and differ only in their appearance and length.Color Status
Off no motor connected
Red motor connected, but no handheld control found
Green motor OK
Green blinking motor OK, but in an end stop
Rot blinking motor conict: CLM-1 assigned to the same function
Red/green blinking calibrating
Cable Appearance
LC-M1 Spiral, 1m long outstretched
LC-M2 Straight, 0.15m long
LC-Z1 Straight, 3.5m long
LC-Z2 Straight, 7m long
Operating