Instruction manual

8
9
3. General Description
The FEM-2 is an expansion module for the ARRIFLEX 435
Advanced camera that provides the following functions:
• LDD (Lens Data Display) interface
• CCU interface (RS232)
• ACC interface
• Time code exposure
according to SMPTE RP136 (Barcode)
• Controls up to three CLM-2 motors
• Two LCS bus interfaces for CLM-1, WHA-2 and ZMU-1
• URM-1 (Universal Radio Module) compatible
Compatibility
To use the FEM-2 with the ARRIFLEX 435 Advanced
the following Versions of Software are necessary:
435 Advanced: SW 2.73 or higher
Firmware 2.65 or higher
WRC-1: V 1.08 or higher
LDD: 2.59 or higher.
The FEM-2 must only be used on the ARRIFLEX
435 Advanced. The attempt to force the
module onto the ARRIFLEX 435 or 435 ES
results in damage to the equipment!
Use only accessories that are compatible
with the FEM-2! Accessories not included in
the compatibility list below must not be used
on the FEM-2!
Incompatible accessories or accessories not
approved by ARRI could damage the FEM-2,
the camera or the accessory itself.
The System