User`s guide
ARRICAM Accessories Quick Guide 01/2004, Page 13 of 24
Mounting and connection
• Mount the SCB to the Remote Control Station by sliding it into place as when mounting it on the Studio camera.
• To fit the MCB/TSB Holder, undo the 3 mm hex screw and remove the cover at the top of the RCS. There is a
handy receptacle on the RCS for storing this cover when it is removed.
• Fix the MCB/TSB Holder on top of the RCS with one 3 mm hex screw.
• Mount the MCB or TSB on the MCB/TSB Holder with the two 3 mm hex screws.
The ARRI Dovetail System allows the RCS to be placed on the camera’s left side (with WHA-2 Rod or Rosette
Brackets) or to the Lite Camera Handle with the Dovetail 3/8” Clamp.
The Cables KC 65-S (3m/9ft) or KC 69-S (15m/45ft) allow the connection of the RCS (SAC connector) with
the camera (CAC connector). These can be extended a further 50m/165ft by using the Cable Drum. Make
sure you don’t connect to the SAC connector of the Speed Control Box by mistake.
Note:
The SCB sync function will not work when using the Cable Drum KC 73-S (50 m/165 ft).
Remote Control Station
SCB
attachments
SCB
connector
OR
OR
OR
SAC
Studio or Lite (CAC connector)
WZU-1
WFU-1
WRC-1
WHA-2
LDDLDD-FP
RCS
SCB
TSB
MCB
MCB/TSB
Holder
The Remote Control Station (RCS) allows the
use of the following accessories remotely:
• Speed Control Box (SCB),
• Manual Control Box (MCB),
• Timing Shift Box (TSB),
• Wired Handgrip Attachment (WHA-2) with
Wireless Focus Unit (WFU-1) and
Wireless Zoom Unit (WZU-1) or
Wireless Remote Control (WRC-1),
• Lens Data Display (LDD),
• Lens Data Display for Focus Puller (LDD-FP)
WHA-2
LDD
MCB/TSB Holder
Accessory Shoe
SAC connector
WHA-2 connector
LDD connector