Instruction manual

102
Erasing the Setting Range
• Press the LENS key ➪ photo and hold down briefly
– LENS-LED switches off.
Matching the Scale Range to the WFU
On the focus scale disk of the WFU a scale range can be
selected by marking as desired. Previously marked focus
disks can be used, e.g. from mechanical follow-focus devices.
For each WFU the scale range is aligned to the stored
setting range of the lens ring as follows:
• With the mechanical end stops ➪ photo of the
handwheel, set the limits of the desired scale range
and fix them.
• Turn the handwheel to the first end stop.
• Press the KNOB key ➪ photo and hold down
– KNOB-LED flashes.
• Turn the handwheel to the second end stop and
release the KNOB key
– KNOB LED illuminates.
Note: With the WMU-3 it is not necessary to hold down
the KNOB-key while moving to the other end-stop.
The other end-stop can be programmed by
pressing the KNOB-key a second time in the
desired position. To erase the programmed
range press the KNOB-key another time.
The set scale range must be at least 30° on the
handwheel. Otherwise the setting will have no
effect.
Operation