Instruction manual

103
Erasing the Scale Range
• Press the KNOB key and hold down briefly
– KNOB-LED switches off.
Using Scales from Mechanical Follow-Focus Devices
If a focus disk is firstly to be marked on a mechanical
follow-focus device and then used on the WFU, it must be
set up on the follow-focus device as follows:
• Turn the handwheel on the follow-focus device
clockwise to the lens end stop.
• Move the index indicator of the follow-focus device to
the disk-positioner pin.
• Fix the index indicator in this position.
• Mark the scale.
Scales marked in this way can be used for LCS focus-iris
operation. Match the scale ranges as described above.
Operation
switch
LENS-key
(handwheel)
locking screw
handwheel
LENS-key
(slider)
KNOB-key
end stops