Instruction manual

105
Defining The Lens Setting Range
For each ring of the lens controlled by the LCS, a setting
range can be defined and stored. The smaller the setting
range, the more precisely setting can be carried out.
With the corresponding control unit (handwheel or slider)
the range can be set as follows:
• Drive to the beginning of the selected range by
adjusting the slider (handwheel).
• Press the LENS key and hold down
– LENS-LED ➪ photo flashes.
• Drive to the end of the selected range by adjusting the
sliding switch.
• Release the LENS key
– LENS-LED illuminates.
The selected operating range must cover at
least 2% of the entire lens range. Otherwise the
setting will have no effect.
Erasing the Setting Range
• Press the LENS key and hold down briefly
– LENS-LED switches off.
Operation
switch
LENS-key
(handwheel)
LENS-key
(slider)
KNOB-key