Instruction manual

109
Operation
5.1.7 LDD-FP (Lens Data Display for
the Focus Puller)
For wireless configurations the LDD-FP can only
be used attached to a WMU-3. The LDD-FP is
not compatible with the WMU-1 or WMU-2.
To operate the LDD-FP with an ARRICAM a Lens
Data Box and LDS-compatible lenses are necessary.
To operate the LDD-FP with an ARRIFLEX 435
Advanced a FEM-2 and LDS-compatible lenses
are necessary.
WZU-1 and WZU-3 must not be attached
between the WMU-3 and the LDD-FP.
The LDD-FP ➪ photo is a small and lightweight Lens
Data Display showing important lens informations and
camera status. It can be configured to show focus, zoom
and iris scale and the camera status in any combination.
The LDD-FP graphically shows depth of field, and allows
for the setting, displaying and storage of focus marks.
Because of its small size it can be mounted in many ways,
allowing the assistant to see precise lens and camera
information while keeping an eye on the action.
• Switch off the WMU-3 with the ON key.
• To detach another unit if attached, press the RELEASE-
button ➪ photo, swing away the other unit and pull
up to remove it.
• Insert the LDD-FP with its wide black pin ➪ photo facing
into the free space on the WMU, then press the LDD-FP
onto the WMU-3 until the module clicks in audibly.
For the configuration and operation of the LDD-FP please
see the instruction manual of the ARRICAM (K5.58508.0).
The cable LDDFP-RDO (0.6m/2ft) connects the LDD-FP to
the Studio Readout or to the Lite Mask Frameglow. With
cable LDDFP-CAC (1.5m/5ft) the LDD-FP can be connec-
ted to the CAC connectors of Studio or Lite. For remote
operation it can be connected to the ARRICAM Remote
Control Station (K2.54143.0) with cable LDDFP-RDO.
Do not use the LDDFP-CAC cable
with the cable drum.