Instruction manual

111
Operation
5.1.8 WEB-3 (Wireless Expansion
Bracket)
The WEB-3 can only be attached to the WMU-3.
The Wireless Expansion Bracket WEB-3 ➪ photo is
mounted on the side of the WMU-3 and allows the
attachement of up to 3 ARRI control units on one WMU-3.
The following combinations are possible:
• LDD-FP and WFU-1 or WFU-3
• LDD-FP and WZU-1 or WZU-3
• LDD-FP and WFU1 or WFU-2 and one
WZU-1 or WZU-3
• LDD-FP and WFU-1 or WFU-3 and ZMU-3
• Two WFU-1 or WFU-3
• Two WFU-1 or WFU-3 and one
WZU-1 or WZU-3
• Two WFU-1 or WFU-3 and ZMU-3
• WRC-1 and WFU-1 or WFU-3
• WRC-1 and WFU-1 or WFU-3 and ZMU-3
• WRC-1 and WFU-1 or WFU-3 and one
WZU-1 or WZU-3
Note: The LDD-FP and the WRC-1 are using the same
interface, therefore simultaneous operation of
both units on one WMU-3 is not possible.
• Connect the WEB-3 with the plug ➪ photo to the
socket on the right side of the WMU-3. Do not use force.
• Fasten the WEB-3 using the two screws ➪ photo.
• Insert the desired module with its wide black pin ➪ photo
facing into the free space on the WEB-3, then press the
module onto the WEB-3 until the module clicks in
audibly.
• To detach another unit if attached, press the RELEASE-
button ➪ photo.