Instruction manual

119
Operation
5.2 Remote Control via Cable
5.2.1 Manual control units
for remote control via cable
For remote control of the lens via cable either
a ZMU-1, ZMU-2 or ZMU-3 (Zoom Main Unit) is necessary
as a main unit, or a WHA-2 / WHA-3 with a FEM-2 on
the ARRIFLEX 435 Xtreme/Advanced or a Lens Data Box
on the ARRICAM can be used.
5.2.2 Operating the ZMU-1 / ZMU-2
(Zoom Main Unit)
5.2.2.1 Switching on
To use CLM-2 motors the ARRICAM must be
equipped with a Lens Data Box, and the
ARRIFLEX 435 Xtreme/Advanced must be
equipped with a FEM-2
An ARRIFLEX 435 Xtreme/Advanced must not
be connected with the following cables: LC-S1, LC-
S2, LC-S3, LC-A1, LC-A2, LC-A3, LC-C1, LC-C2.
• Before switching on, ensure that
- the support rods are securely fastened to the camera,
- the motor unit is securely fastened to the support rods,
- the motor drive gear engages the lens gear ring with
as little play as possible.
• If a Universal Motor Controller UMC is to be used,
switch its main switch ➪ photo to ON. If an ARRI-
CAM or an ARRIFLEX 435 Xtreme/Advanced is used,
switch on the camera.
• Switch on the power supply with the POWER key ➪
photo on the Zoom Main Unit ZMU.
Note: If the Universal Motor Controller UMC, an
ARRICAM or an ARRIFLEX 435 Xtreme/
Advanced is switched off and on again, the
ZMUmust also be reset by switching off and on.
Note: Wireless units can also be directly connected
using the WC-A3 cable.