Instruction manual

121

LED

drive direction switch

CLM-1

The READY-LEDs on the ZMU ➪ photo and the motor

unit CLM-1 or the UMC, ARRICAM or ARRIFLEX 435

Xtreme/Advanced brieﬂy illuminate red, then the READY-

LED on the ZMU displays the status of the LCS:

green LCS is ready for operation

red operating error on one unit

(e.g. incorrect key pressed,

ZMU switched on before

UMC /ARRICAM / ARRIFLEX 435 Xtreme/Advanced)

power cable LC-S1 defective

(see also chapter 7. Trouble-Shooting)

ﬂashing red selector switch on the motor unit is incorrectly set

or connected to the incorrect socket of the UMC, FEM-2

or on the LDB of the ARRICAM

motor unit is not connected

cable defective (see also chapter 7. Trouble-Shooting)

Note: The LEDs on the CLM-1 ➪ photo or the UMC,

FEM-2 or the LDB ➪ photo ﬂash green if the

lens is at the end of the set operating range.

• Then press the CAL key ➪ photo on the ZMU to

calibrate the motor end stops.

• Select the desired drive direction of the zoom adjust-

ment with the drive direction switch on the CLM-1 motor

➪ photo unit or on the zoom socket on the UMC,

FEM-2 or the LDB ➪ photo.

Operation