Instruction manual

129
WZB-3KC-105
Operation
5.2.3 Operating the ZMU-3
(Zoom Main Unit)
5.2.3.1 Switching on
Operating with a CLM-2 motor:
The ZMU-3 can be connected directly with the Y-cable
KC-91S (K2.65008.0) to a CLM-2 Motor and the RS-
socket. The power will be supplied through the RS-socket.
Operating on the LCS bus:
The ZMU-3 can be connected to the UMC, FEM-2 or the
LDB-ST/LT with the cables KC92-S (K2.65009.0) or
KC93-S (10m) (K2.65010.0).
The ARRIFLEX 435 Advanced or the
ARRIFLEX 435 Xtreme must not be connected
with the following cables:
LC-S1, LC-S2, LC-A1, LC-A2, LC-A3, LC-C1,
LC-C2.
• Switch on the UMC if used. Switch on the ARRICAM
or ARRIFLEX 435 Xtreme/Advanced if used.
Operating wirelessly:
The ZMU-3 can be connected to the WMU-3 with the cable
KC-105 (K2.65036.0) to allow for wireless operation.
Note: Software version 1.02 or above is necessary
for wireless operation of the ZMU-3 with all
display functions.
• The ZMU-3 can be mounted to the WMU-3 by using
the Wireless Zoom Bracket WZB-3 ➪ photo.