Instruction manual

130
A B C
Operation
5.2.3.2 Switching on
• Before switching on, make sure that
- the support rods are securely fastened to the camera
- the motor units are securely fastened to the support rods
- and the motor drive gear engages the lens gear ring
with as little play as possible.
After connecting to the RS/LCS socket three lines briefly
flash up in the speed display (➪ photo A).
The zooming speed previously used is then shown on the
display. The status display indicates ready with the rdy
display (➪ photo B).
In case a zoom range was previousely stored this is now
shown on the marking display (➪ photo C).
Note: In wireless operation the zoom range must be
executed one time in order to show up on the
display.