Instruction manual

145
Operation
After switching on, the memory banks are locked to prevent
accidental erasure of stored data.
Selecting Memory Bank
• Press the MEM key ➪ photo repeatedly until the
desired memory bank is active.
Recording Operating Functions
• Select the desired memory bank.
• To initialize:
Depress the REC key – the REC-LED ➪ photo will
flash. The LCS is ready for recording. This status can
be cancelled by pressing the MEM key. If no memory
bank has been pre-selected, memory bank LEDs 1 and
2 will flash. Select memory bank!
• To start recording:
Press the REC key again. During recording, the REC-
LED will illuminate.
• To stop recording:
Press the REC key again or wait until the entire
sequence has been recorded.
Playback Operating Functions
• Select the desired memory bank.
• To set the starting position:
press the PLAY key ➪ photo.
During the search for the start positions, the PLAY-LED
➪ photo will flash quickly; once the positions have
been reached, the LED will flash slowly.
The unit is ready for playback. This status can be
cancelled by pressing the MEM key.
If there is no recorded data in the memory bank, both
memory bank LEDs will flash, and the READY-LED on
the zoom unit will be illuminated red. Select the correct
memory bank!
• To start playback:
press the PLAY key again.
During playback the PLAY-LED will be illuminated.
• To stop playback:
press the PLAY key again or wait until the entire
sequence has been played back.