Instruction manual

150
Operation
5.2.7.1 Setup
• Make sure that the lens motor is tightly attached to the
support rods, and that the support rods are tightly
locked into the sliding base plate.
• Switch the selector switch on CLM-1 lens motors
➪ photo to IRIS or connect CLM-2 motors to the IRIS
socket ➪ photo of the UMC.
Note: The lens motors can be adapted to attach either
to the ø 19 mm or to the ø 15 mm support rods.
Make sure you have the correct attachment for
the lens motor.
Note: Some older lenses do not have the proper gear
ring on the iris ring. Make sure that all lenses to
be used have the proper gear on the iris ring
(see chapter 6.7 Iris Gear Rings).
IRIS-socket
UMC
selector switch
CLM-1