Instruction manual

151
Operation
ICU-1 Connecting Cables
The ICU-1 identifies different camera models through
different cables.
The ICU-1 and the lens motor are generally powered from
the camera, but can also be connected to a separate 12 or
24 Volt battery (with cable LC-S1). The ICU-1 will auto-
matically detect if the incoming voltage is 12 or 24 Volts.
Note: If the camera runs on 12 V, it is recommended
to use a separate 24 Volt battery for the ICU-1.
The lens motor will be able to respond at a faster
rate when connected to a 24V power source.
Note: When powering the ICU-1 and the Motors from
the camera, make sure that the maximum load
of the used connector on the camera is not
exceeded
• Make cable connections according to the diagram.
To power the ICU-1 from a separate battery, connect
cable LC-S1 to the battery and to the unused connector
on the lens motor.
Camera Camera Cable
ARRICAM ST/LT KC 72 cable to CAC receptable
Part number: K2.54137.0
ARRIFLEX 535 Connect LC-D1 to RU receptacle
535B Connect LC-D1 to ACC receptacle
16SR 3 Connect LC-D1 to ACC receptacle
16SR 3 HS Connect LC-D1 to ACC receptacle
435ES Connect LC-D1 to RU receptacle
435 Adv. Part number: K2.47029.0
ARRIFLEX 35 III Connect LC-D2 to 11 pin accessory receptacle
435 Part number: K2.47030.0
435ES
435 Adv.
ARRIFLEX 16SR Connect LC-D4 to 11 pin accessory receptacle
16SR II Part number: K2.47048.0
16SR II HS
ARRIFLEX 765 Connect LC-D3 to SCU receptacle
Part number: K2.47031.0