Instruction manual

155
Operation
5.2.7.2 Turning ICU-1 Power On
• Push the POWER key ➪ photo to switch on the ICU-1.
• The READY LEDs on the ICU-1 and on the lens motor
will illuminate briefly and then indicate the system
status. See table below.
BAT-LED
CAL-LED
SET F-STOP-LED
NON LINEAR-LED
POWER-key (ON)
READY-LED
CAL-key
F-STOP-key
OPEN-key
CLOSE-key
ICU READY LED Camera ICU Lens motor
Slow green flashing Standby Ready Ready
Fast green flashing Ramping up to speed Set to beginning F-Stop Ready
Steady green light Running at speed Will follow any frame rate changes Will follow any frame rate changes
Red See ”Trouble Shooting” chapter
Red/green flashing See ”Trouble Shooting” chapter
Setting ICU-1 Reaction Speed
The ICU-1 can be set to a fast or slow reaction speed.
This setting determines how fast the ICU-1 reacts to a
change in the camera’s frame rate.
For most cameras, the fast reaction speed should be used.
If you detect a jittering in the lens motor while the camera
is running at a constant speed, or a jerky motor movement