Instruction manual

164
Operation
Resetting after a Lens Change
• Swing the lens motor back onto the iris ring and tighten it.
Make sure that the lens motor gear meshes with the
iris ring gears without any play.
• Make sure that the lens motor is tightly attached to the
support rods, and that the support rods are tightly
locked into the sliding base plate.
• Switch the ICU-1 on.
• Calibrate the ICU-1.
• Assign F-Stops.
If the Iris Ring Moves While Power is Off
If the iris ring is moved while the ICU-1 is switched off,
the end positions memorized in the ICU-1 and the actual
end positions of the iris ring will no longer be the same!
• Switch the ICU-1 on and re-calibrate.
It is not necessary to assign new F-Stops.