Instruction manual

176
6.2 Offset Mounting
If the motor unit CLM-1 is to be used on a short lens, a
different offset clamp unit should be mounted to reach the
iris control ring of the lens.
Order numbers:
K2.41381.0 ........................................ for ø 19mm rods
K2.41380.0 ........................................ for ø 15mm rods
To replace the offset clamp unit
• Remove the two screws on the bottom of the motor unit
and the screws on the side ➪ photo.
• Replace clamp unit.
• Replace screws.
screws
Mechanical Acessories