Instruction manual

181
7. Trouble-Shooting 7.1 Power Supply
No Reaction when switched on Battery empty Check battery level
camera switched off When power is supplied through camera, switch it on
Main fuse defective Replace fuse in the LC-S1, S2, S3, S4. The UMC and the
UC-S1-S are equipped with self-resetting fuses
Switch off, wait several seconds, switch on
More than one CLM-1 motor supplied through camera Only one CLM-1 motor unit can be supplied through the
camera (danger of overload)
Power cable LC-S1, S2, S3, S4 defective Connect power cable LC-S1, S2, S3, S4 directly
to the zoom unit and press POWER key.
If no reaction, replace power cable
Power cable UC-A1 or UC-S1 defective Replace power cable
Zoom cable LC-Z1 or LC-Z2 defective When using several motor units, connect zoom cable directly
Motor cable LC-M1 or LC-M2 defective to the motor unit to which the power cable LC-S1 is also
connected. If no reaction, replace zoom cable.
Otherwise replace motor cable.
Trouble-Shooting
Problem Cause Remedy