Instruction manual

183

Trouble-Shooting

Problem Cause Remedy

7.3 CLM-1 Motor Unit LEDs

READY LED ﬂashes red Several motor units are set to the same switch off ZMU, WMU and UMC.

operational function or plugged into the UMC. set selector switch on the motor units

The READY LEDs on the manual control units to the corresponding function, switch on.

also ﬂash red

Motor cable LC-M1 or LC-M2 defective check all motor cables and replace if necessary

READY-LED illuminated red Operational error, e.g. selector switch on motor reset to original setting

unit was operated while the unit was switch off ZMU, WMU and UMC,

switched on check settings on control units

and motor units, switch on

Power cable LC-S1 defective Replace power cable