Instruction manual

189

Trouble-Shooting

Problem Cause Remedy

CAL-LED ﬂashes Motor units were replaced recalibrate

or moved.

After switching on again,

the end stops are incorrect

Stops not yet deﬁned recalibrate

or lens was moved

while LCS was switched off and

then driven against the stop

Lens ring does not move freely Check for damage of lens ring

and movability

Battery Control (BAT) illuminated Battery nearly empty Replace battery

Do not start any new scenes!

Battery Control (BAT) ﬂashes Battery empty Replace battery immediately;

danger of deeply discharging

ZMU-3 display ﬂashes alternatively Joystick is not in middle position when switching on do not operate the joystick while switching on;

with Joy / speed value joystick defective