Instruction manual

191

Trouble-Shooting

Problem Cause Remedy

CAL-LED ﬂashes Stops not yet deﬁned or lens was moved recalibrate

while LCS was switched off and then driven

against the stop

Lens ring does not move freely check for damage of lens ring

and movability

7.9 ICU-1 Iris Control Unit LEDs

READY LED ﬂashes red Camera cable shows invalid camera ID use correct cable

No lens motor or more than one have been set to IRIS only one motor unit must be set to IRIS

READY LED illuminated red A locked button has been pressed all buttons are locked while camera is running

READY LED ﬂashes green/red The Lens motor has reached a lens end-stop the LED will ﬂash until any button is pressed

while the camera was running. to reset it.

(even if the CLM is positioned no longer

at the end stop)