Instruction manual

35
System Overview
WEU-1 Wireless Extension Unit
K2.52056.0
The extension WEU-1 ➪ photo consists of three components
which enable the WMU-1 to be worn on a belt so that only
the manual control unit needs to be held:
the adapter WHA-1 (Wireless Handgrip Attachment),
➪ photo, the cable WC-E1 ➪ photo and the WMA-1
(Wireless Main Attachment) ➪ photo.
WHA-2 Wired Handgrip Attachment
K2.54079.0
With this handgrip attachment ➪ photo the hand units of
the wireless Lens Control System (WFU-1, WFU-3 and/or
WZU-1, WZU-3) or the Wireless Remote Control (WRC-1)
can be operated hardwired. The WHA-2 works with the
ARRIFEX 435 Xtreme/Advanced if a FEM-2 is present as
well as with the ARRICAM Studio and ARRICAM Lite. It
can be connected to the LCS socket of a Lens Data Box
with cable LC-M1, LC-M2, LC-Z1 or LC-Z2. Alternatively
it can be connected to the CAC connector of Studio or Lite
using cable KC-70 (3m/9ft). For lens control on an
ARRICAM, a Lens Data Box must be present.
The LDD-FP can not be attached to the WHA-2.
The WHA-2 is not compatible with the UMC-1.
WHA-3 Wired Handgrip Attachment
K2.52254.0
The WHA-3 ➪ photo, just like the WHA-2, allows all hand
controllers except the LDD-FP to be connected with a cable
to 435 Advanced with FEM-2 or to an ARRICAM Lens Data
Box. In addition the WHA-3 has a button on the left side
for focus tracking. Focus tracking based on measured distances
is available when using an ARRICAM with the Lens Data
Display for Focus Puller (LDD-FP) and a compatible
distance measurement device.
The LDD-FP can not be attached to the WHA-3.
Studio LDB Adapter
K2.54144.0
The Studio LDB Adapter ➪ photo allows the mounting of
the Studio Lens Data Box 1m/3ft away from the camera
body.