Instruction manual

63
plug
• URM-2 / URM-3 with the WMU-2, WMU-3 (and LDB-ST-2
LDB-LT-2, UMC-3).
All radio modules are attached in same way:
• Remove all cables from the UMC.
• Screw the antenna ➪ photo onto the threaded
bushing on the URM-1 / URM-2 / URM-3.
• Unscrew both screws ➪ photo from the cover and
remove the cover.
• Place the URM onto the UMC-1, align both plugs
➪ photo with each other and do not tilt them while
attaching.
• Screw the URM tight to the UMC-1 with the two screws.
Note: To operate an ARRICAM or an ARRIFLEX 435
Xtreme/Advanced with a FEM-2 a UMC-1 is not
necessary.
The functions of the UMC-1 are already incorporated
in the FEM-2 or a Lens Data Box of an ARRICAM.
Parallel operation an UMC with a respectively
equipped ARRICAM or ARRIFLEX 435 Xtreme/
Advanced is not recommended!
Setup