Instruction manual

Attaching a URM to the FEM-2

For radio operation of the ARRIFLEX 435 Xtreme/Advanced

the FEM-2 ➪ photo must be equipped with a URM ➪ photo.

According to the system in use URM-1, URM-2 or URM-3

modules can be attached. Compatible are:

• URM-1 with the WMU-1 (and LDB-ST and LDB-LT), or

• URM-2 / URM-3 with the WMU-2, WMU3 (and LDB-ST-2

LDB-LT-2, UMC-3).

All radio modules are attached in same way:

• Remove all cables from the FEM-2.

• Screw the antenna ➪ photo onto the threaded

bushing on the URM.

• Unscrew both screws ➪ photo from the cover and

remove the cover.

• Place the URM onto the FEM-2, align both plugs ➪ photo

with each other and do not tilt them while attaching.

• Screw the URM tight to the FEM-2 with the two screws.

For the attachment of the FEM-2 to the ARRIFLEX 435

Xtreme/Advanced and the operation please refer to the

respective instruction manual (K5.60901.0 German and

K5.60902.0 English).

screws

Setup