Instruction manual

4.2 Attaching and Connecting the Manual Control Units

After cabling up the motors and their power supplies, it is

necessary to deﬁne which manual control units will be used

to control the motors. The selection can be made using the

diagram on ➪ the fold-out page in the back of this

manual. In the squares is listed which units and cables are

necessary for the desired application.

Connect the cables listed in the diagram with the different

units according to the following table:

To cable the cable manual control units

Code Description Connection between Length / m Plug with no. pins

LC-Z1 Zoom cable ZMU / CLM-1 3.5 Fischer 5 Fischer 5

LC-F1 Focus cable ZMU or FIU-1 / FIU-1 2 Fischer 10 Fischer 10

LC-F2 Focus cable ZMU or FIU-1 / FIU-1 0.2 Fischer 10 Fischer 10

WC-W1 WHA-1 with WRC-1 WHA-1 with WRC-1 / 16 SR3, 535, 2 Fischer 8 Fischer 16

435, 435ES, 435 Adv. with FEM-1

LC-M1 WHA-2/3 LCS Cable WHA-2/3 / LDB, RCS, 435 Adv+FEM-2 1 Fischer 5 Fischer 5

LC-Z1 WHA-2/3 LCS Cable WHA-2/3 / LDB, RCS, 435 Adv+FEM-2 3,5 Fischer 5 Fischer 5

KC 70 WHA-2/3 CAC Cable ARRICAM ST/LT WHA-2/3 3 Fischer 16 Fischer 5

Note: The focus iris unit FIU-1 cannot be used together

with a WFU-1 or WFU-3 in radio operation

since these units cover the same functions.

Note: The zoom cable LC-Z1 can be extended by 75 m

with the cable drum LC-E1.

Setup