Instruction manual

Note: The camera (ARRICAM with LDB or ARRIFLEX

435 Xtreme/Advanced with FEM-2) or the UMC

must always be switched on prior to the WMU.

• Switch on the power supply with the ON key ➪ photo

on the WMU.

Note: If the ARRICAM with LDB, the ARRIFLEX 435

Xtreme/Advanced with FEM-2 or the UMC is

switched off while radio contact exists, all connected

WMUs will also be automatically switched off.

The READY LEDs on the WMU ➪ photo and the motor

unit CLM-1 or the universal motor controller UMC will

brieﬂy illuminate red. Then the Ready LED on the WMU-1

will show the status of the LCS:

green LCS is ready for operation

red operating error on one unit (e.g. incorrect key pressed,

WMU switched on before UMC)

ﬂashing red the selector switch on the motor unit is incorrectly set

or connected to the incorrect socket on the UMC

Note: The LEDs on the CLM-1 or UMC, LDB or FEM-2

ﬂash green when the lens reaches the end of the

set operating range.

Operation

READY-LED

main switch WMU-3 main switch WMU-1/-2