Instruction manual

82
• Calibrate the motor end stops by pressing the CAL-key
➪ photo on the WMU. During calibration no WMU
can be switched on.
Note: All WMUs or ZMUs must calibrate all lens rings
assigned to the respective unit.
• Select the desired direction with the drive direction
switch on the CLM-1 motor unit ➪ photo or on the
respective switches close to the motor sockets on the
LDB, FEM-2 or the UMC ➪ photo.
Operation
CAL-key
drive direction switch
CLM-1
CAL-key