User's Manual

51
CHAPTER 4 Command Line Interface
The Motorola Netopia® Gateway operating software includes a command line interface (CLI) that lets you access
your Motorola Netopia® Gateway over a telnet connection. You can use the command line interface to enter and
update the unit’s configuration settings, monitor its performance, and restart it.
This chapter covers the following topics:
◆ “Overview” on page 52
◆ “Starting and Ending a CLI Session” on page 54
◆ “Using the CLI Help Facility” on page 54
◆ “About SHELL Commands” on page 55
◆ “SHELL Commands” on page 56
◆ “About CONFIG Commands” on page 64
◆ “CONFIG Commands” on page 67
CONFIG Commands
“Connection commands” on page 67
“IP DNS commands” on page 68
“IP IGMP commands” on page 69
“NTP commands” on page 71
“IP Gateway commands” on page 71
“Application Layer Gateway (ALG) commands” on page 72
“Link commands” on page 72
“Management commands” on page 73
“Physical interfaces commands” on page 74
“PPPoE relay commands” on page 76
“NAT Pinhole commands” on page 77
“System commands” on page 78