User Manual

20
Safety
Getting
Started Installation
Ethernet
Configuration Usage Troubleshooting Glossary
Touchstone DG1660 Data Gateway User’s Guide
1 Position the mounting bracket on the surface where you intend to mount
the Data Gateway and mark the two holes with a pencil.
2 Drill holes through the marked locations for the mounting screws.
3 If using drywall anchors, set them into the wall. Then, drive the screws into
the wall leaving a gap of about 1/8” (3 mm) between the screw head and
the wall. If not using anchors, just drive the screws.
4 Slip both mounting slots in the back of the mounting bracket over the
screws, then slide the bracket down until the narrow end of the keyhole slot
contacts the screw shaft.
5 Hang the Data Gateway on the wall by inserting the six tabs on the mount-
ing bracket into the six slots in the back of the Data Gateway and sliding the
Data Gateway down until it drops in place on the bracket.
6 Proceed to Connecting the Data Gateway.
Desktop mounting instructions
1 Position the Data Gateway so that:
• it stands vertically on its base. (Do not lay it flat on its side.)
• air flows freely around it
• the back faces the nearest wall
• it will not fall to the floor if bumped or moved
• the ventilation holes on the sides of the unit are not blocked.
2 Proceed to Connecting the Data Gateway.
Step 1
Step 2
Step 3
Step 4
Step 5