User's Manual
Table Of Contents
- Table of Contents
- CHAPTER 1 Introduction
- CHAPTER 2 Device Configuration
- Important Safety Instructions
- Motorola® Gateway Status Indicator Lights
- Battery Installation (optional)
- Battery Door Installation Instructions
- Battery Door Removal Instructions
- Cradle Installation Instructions
- Set up the Motorola Gateway
- Accessing the Web Management Interface
- Device Status page
- Tab Bar
- Help
- Links Bar
- Broadband
- Home Network
- Voice
- Firewall
- Diagnostics
- CHAPTER 3 Basic Troubleshooting
- CHAPTER 4 Command Line Interface
- Overview
- Starting and Ending a CLI Session
- Using the CLI Help Facility
- About SHELL Commands
- SHELL Commands
- About CONFIG Commands
- CONFIG Commands
- Connection commands
- Filterset commands
- Queue commands
- IP Gateway commands
- IPv6 Commands
- IP DNS commands
- IP IGMP commands
- NTP commands
- Application Layer Gateway (ALG) commands
- Dynamic DNS Commands
- Link commands
- Management commands
- Remote access commands
- Physical interfaces commands
- PPPoE relay commands
- NAT Pinhole commands
- Security Stateful Packet Inspection (SPI) commands
- VoIP commands
- System commands
- Debug Commands
- CHAPTER 5 Technical Specifications and Safety Information
- Appendix A Motorola® Gateway Captive Portal Implementation
- Appendix B Quality of Service (QoS) Examples
- Index
Administrator’s Handbook
104
CONFIG Commands
“Connection commands” on page 121
“Filterset commands” on page 124
“Queue commands” on page 128
“IP Gateway commands” on page 130
“IPv6 Commands” on page 130
“IP DNS commands” on page 138
“IP IGMP commands” on page 139
“NTP commands” on page 141
“Application Layer Gateway (ALG) commands” on page 142
“Dynamic DNS Commands” on page 142
“Link commands” on page 143
“Management commands” on page 146
“Remote access commands” on page 148
“Physical interfaces commands” on page 150
“PPPoE relay commands” on page 156
“NAT Pinhole commands” on page 157
“Security Stateful Packet Inspection (SPI) commands” on page 157
“VoIP commands” on page 159
“System commands” on page 167