User's Manual
Table Of Contents
- Table of Contents
- CHAPTER 1 Introduction
- CHAPTER 2 Device Configuration
- Important Safety Instructions
- Motorola® Gateway Status Indicator Lights
- Battery Installation (optional)
- Battery Door Installation Instructions
- Battery Door Removal Instructions
- Cradle Installation Instructions
- Set up the Motorola Gateway
- Accessing the Web Management Interface
- Device Status page
- Tab Bar
- Help
- Links Bar
- Broadband
- Home Network
- Voice
- Firewall
- Diagnostics
- CHAPTER 3 Basic Troubleshooting
- CHAPTER 4 Command Line Interface
- Overview
- Starting and Ending a CLI Session
- Using the CLI Help Facility
- About SHELL Commands
- SHELL Commands
- About CONFIG Commands
- CONFIG Commands
- Connection commands
- Filterset commands
- Queue commands
- IP Gateway commands
- IPv6 Commands
- IP DNS commands
- IP IGMP commands
- NTP commands
- Application Layer Gateway (ALG) commands
- Dynamic DNS Commands
- Link commands
- Management commands
- Remote access commands
- Physical interfaces commands
- PPPoE relay commands
- NAT Pinhole commands
- Security Stateful Packet Inspection (SPI) commands
- VoIP commands
- System commands
- Debug Commands
- CHAPTER 5 Technical Specifications and Safety Information
- Appendix A Motorola® Gateway Captive Portal Implementation
- Appendix B Quality of Service (QoS) Examples
- Index
Administrator’s Handbook
122
set conn name name icmp-echo-drop [ off | on ]
If set to on, drops echo-requests received on the particular interface. The default is off.
set conn name name icmp-err-suppress [ off | on ]
An additional option to suppress ICMP error messages on WAN IP interfaces. The default is off.
set conn name name static ipaddr ipaddr
Specifies a static IP address when the connection type has been set to static. The default is 192.168.1.254.
☛ Note:
You must also set the gateway address OR turn it off, otherwise the settings cannot be saved. See
“IP Gateway commands” on page 130.
Example:
NOS/128600225634272/conf
Config Mode v1.3
NOS/128600225634272 (top)>> conn
NOS/128600225634272 (conn)>> set
conn
(conn) node list ...
"LAN"
"WAN"
Select (name) node to modify from list,
or enter new (name) to create.
conn name (?):
name "LAN"
link-oid ("LAN") [ LAN | WAN | PPPoE | ]:
type (static) [ static | dhcpc | ppp ]:
side (lan) [ lan | wan ]:
lan-type (private) [ private | public | public-delegated ]:
mcast-forwarding (off) [ off | on ]:
rip-send (off) [ off | v1 | v2 | v1-compat | v2-md5 ]:
rip-receive (off) [ off | v1 | v2 | v1-compat | v2-md5 ]:
fs-egress ("") [ Security | QosUpstream | WanEgress | ]:
fs-ingress ("") [ Security | QosUpstream | WanEgress | ]:
static
ipaddr ("192.168.1.254"):
netmask ("255.255.255.0"):
dhcp-server-enable (on) [ off | on ]:
dhcp-server
start-addr ("192.168.1.64"):
end-addr ("192.168.1.253"):
lease-time (01:00:00:00):
subnet-order (1) [ 1 - 8 ]:
gen-option
(gen-option) node list ...
Select (name) node to modify from list,
or enter new (name) to create.