User's Manual
Table Of Contents
- Table of Contents
- CHAPTER 1 Introduction
- CHAPTER 2 Device Configuration
- Important Safety Instructions
- Motorola® Gateway Status Indicator Lights
- Battery Installation (optional)
- Battery Door Installation Instructions
- Battery Door Removal Instructions
- Cradle Installation Instructions
- Set up the Motorola Gateway
- Accessing the Web Management Interface
- Device Status page
- Tab Bar
- Help
- Links Bar
- Broadband
- Home Network
- Voice
- Firewall
- Diagnostics
- CHAPTER 3 Basic Troubleshooting
- CHAPTER 4 Command Line Interface
- Overview
- Starting and Ending a CLI Session
- Using the CLI Help Facility
- About SHELL Commands
- SHELL Commands
- About CONFIG Commands
- CONFIG Commands
- Connection commands
- Filterset commands
- Queue commands
- IP Gateway commands
- IPv6 Commands
- IP DNS commands
- IP IGMP commands
- NTP commands
- Application Layer Gateway (ALG) commands
- Dynamic DNS Commands
- Link commands
- Management commands
- Remote access commands
- Physical interfaces commands
- PPPoE relay commands
- NAT Pinhole commands
- Security Stateful Packet Inspection (SPI) commands
- VoIP commands
- System commands
- Debug Commands
- CHAPTER 5 Technical Specifications and Safety Information
- Appendix A Motorola® Gateway Captive Portal Implementation
- Appendix B Quality of Service (QoS) Examples
- Index
151
set physical dsl profile-8c [ on | off ]
Enables or disables VDSL2 profile 8c governing upstream and downstream bandwidth. Default is on.
set physical dsl profile-8d [ on | off ]
Enables or disables VDSL2 profile 8d governing upstream and downstream bandwidth. Default is on.
set physical dsl profile-12a [ on | off ]
Enables or disables VDSL2 profile 12a governing upstream and downstream bandwidth. Default is on.
set physical dsl profile-12b [ on | off ]
Enables or disables VDSL2 profile 12b governing upstream and downstream bandwidth. Default is on.
set physical dsl profile-17a [ on | off ]
Enables or disables VDSL2 profile 17a governing upstream and downstream bandwidth. Default is on.
set physical dsl profile-30a [ on | off ]
Enables or disables VDSL2 profile 30a governing upstream and downstream bandwidth. Default is off.
set physical dsl bit-swap [ on | off ]
Turns DSL bit-swapping on or off. Bit-swapping is resilient to loss of hand-shake commands. Default is on.
set physical dsl trellis [ on | off ]
Turns trellis error correction encoding on or off. Default is on.
set physical dsl vectoring-enable [ off | on ]
Enables or disables VDSL2 vectoring. Vectoring enables VDSL2 to achieve its highest potential data rates,
exceeding 100 Mbps. Default is off.
set physical dsl vectoring-timeout-ms milliseconds
If vectoring-enable is set to on, specifies a timeout interval in milliseconds. Default is 5000.
set physical dsl nlnm-threshold [ 0 - 480 ]
Specifies the New Low Noise Model (NLNM) value between 0 and 480. Default is 60.
set physical dsl transport [ atm | ptm | auto | off ]
Sets the DSL transport mode: Asynchronous (atm), Packet (ptm), Automatic (auto), or none (off). Default is ptm.
set physical dsl atm vcc 1 enable [ off | on ]
Turns atm on or off on vcc 1. Default is on.