User's Manual
Table Of Contents
- Table of Contents
- CHAPTER 1 Introduction
- CHAPTER 2 Device Configuration
- Important Safety Instructions
- Motorola® Gateway Status Indicator Lights
- Battery Installation (optional)
- Battery Door Installation Instructions
- Battery Door Removal Instructions
- Cradle Installation Instructions
- Set up the Motorola Gateway
- Accessing the Web Management Interface
- Device Status page
- Tab Bar
- Help
- Links Bar
- Broadband
- Home Network
- Voice
- Firewall
- Diagnostics
- CHAPTER 3 Basic Troubleshooting
- CHAPTER 4 Command Line Interface
- Overview
- Starting and Ending a CLI Session
- Using the CLI Help Facility
- About SHELL Commands
- SHELL Commands
- About CONFIG Commands
- CONFIG Commands
- Connection commands
- Filterset commands
- Queue commands
- IP Gateway commands
- IPv6 Commands
- IP DNS commands
- IP IGMP commands
- NTP commands
- Application Layer Gateway (ALG) commands
- Dynamic DNS Commands
- Link commands
- Management commands
- Remote access commands
- Physical interfaces commands
- PPPoE relay commands
- NAT Pinhole commands
- Security Stateful Packet Inspection (SPI) commands
- VoIP commands
- System commands
- Debug Commands
- CHAPTER 5 Technical Specifications and Safety Information
- Appendix A Motorola® Gateway Captive Portal Implementation
- Appendix B Quality of Service (QoS) Examples
- Index
41
Home Network
When you click the Home Network tab, the Home Network Status page appears.
The Home Network Status page displays informa-
tion about the Gateway’s local area network.
If you click the
Run Congestion Detection but-
ton, the device will generate statistics for each of the
11 channels available, displaying:
◆Channel number
◆AP Count
◆Congestion Score (1 - 10)
You can clear the current statistics information by
clicking the
Clear Statistics button.