User's Manual
Table Of Contents
- Table of Contents
- CHAPTER 1 Introduction
- CHAPTER 2 Device Configuration
- Important Safety Instructions
- Motorola® Gateway Status Indicator Lights
- Battery Installation (optional)
- Battery Door Installation Instructions
- Battery Door Removal Instructions
- Cradle Installation Instructions
- Set up the Motorola Gateway
- Accessing the Web Management Interface
- Device Status page
- Tab Bar
- Help
- Links Bar
- Broadband
- Home Network
- Voice
- Firewall
- Diagnostics
- CHAPTER 3 Basic Troubleshooting
- CHAPTER 4 Command Line Interface
- Overview
- Starting and Ending a CLI Session
- Using the CLI Help Facility
- About SHELL Commands
- SHELL Commands
- About CONFIG Commands
- CONFIG Commands
- Connection commands
- Filterset commands
- Queue commands
- IP Gateway commands
- IPv6 Commands
- IP DNS commands
- IP IGMP commands
- NTP commands
- Application Layer Gateway (ALG) commands
- Dynamic DNS Commands
- Link commands
- Management commands
- Remote access commands
- Physical interfaces commands
- PPPoE relay commands
- NAT Pinhole commands
- Security Stateful Packet Inspection (SPI) commands
- VoIP commands
- System commands
- Debug Commands
- CHAPTER 5 Technical Specifications and Safety Information
- Appendix A Motorola® Gateway Captive Portal Implementation
- Appendix B Quality of Service (QoS) Examples
- Index
45
Link: HPNA Configure
When you click the HPNA Configure link, the HPNA Configure page for the HomePNA network appears.
Here you can turn HomePNA Networking On or Off.
If desired, you can choose the Output Jack, either the Coax jack or the Phone jack, or let the device Auto sense
it automatically.
Click the
Save button.