User's Manual
Table Of Contents
- Table of Contents
- CHAPTER 1 Introduction
- CHAPTER 2 Device Configuration
- Important Safety Instructions
- Motorola® Gateway Status Indicator Lights
- Battery Installation (optional)
- Battery Door Installation Instructions
- Battery Door Removal Instructions
- Cradle Installation Instructions
- Set up the Motorola Gateway
- Accessing the Web Management Interface
- Device Status page
- Tab Bar
- Help
- Links Bar
- Broadband
- Home Network
- Voice
- Firewall
- Diagnostics
- CHAPTER 3 Basic Troubleshooting
- CHAPTER 4 Command Line Interface
- Overview
- Starting and Ending a CLI Session
- Using the CLI Help Facility
- About SHELL Commands
- SHELL Commands
- About CONFIG Commands
- CONFIG Commands
- Connection commands
- Filterset commands
- Queue commands
- IP Gateway commands
- IPv6 Commands
- IP DNS commands
- IP IGMP commands
- NTP commands
- Application Layer Gateway (ALG) commands
- Dynamic DNS Commands
- Link commands
- Management commands
- Remote access commands
- Physical interfaces commands
- PPPoE relay commands
- NAT Pinhole commands
- Security Stateful Packet Inspection (SPI) commands
- VoIP commands
- System commands
- Debug Commands
- CHAPTER 5 Technical Specifications and Safety Information
- Appendix A Motorola® Gateway Captive Portal Implementation
- Appendix B Quality of Service (QoS) Examples
- Index
81
Here is an example of the Ethernet Details screen.
Test Internet Access
These tests send a PING from the modem to either the LAN or WAN to verify connectivity. A PING could be either
an IP address (163.176.4.32) or Domain Name (www.motorola.com). You enter a web address URL or an IP
address in the respective field.
Click the Ping, Trace, NSLookup, or Detect Missing Filter button.
Results will be displayed in the Progress Window as they are generated.
◆ Ping - tests the “reachability” of a particular network destination by sending an ICMP echo request and waiting
for a reply.
◆ Traceroute - displays the path to a destination by showing the number of hops and the router addresses of
these hops.
◆ NSLookup - converts a domain name to its IP address and vice versa.
◆ Detect Missing Filter - if you click the Detect Missing Filter button, a warning message appears at the top
since the detection takes up to 2 minutes. When completed the Progress area might look like following.
To use the Ping capability, type a destination address (domain name or IP address) in the text box and click the
Ping, Trace, or Lookup button. The results are displayed in the Progress Window.
This sequence of tests takes approximately one minute to generate results. Please wait for the test to run to com-
pletion.
Each test generates one of the following result codes:
Result Meaning
* PASS: The test was successful.
* FAIL: The test was unsuccessful.