User Manual

B
Testing Network Connectivity with the SBG941
To check connectivity between the SBG941 and other devices on the SBG941 LAN,
perform the following test:
1. Select Ping from the Select Utility drop-down list.
2. Enter the IP address of the computer you want to Ping in the Target field.
3. Enter the data packet size in bytes in the Ping Size field.
4. Enter the number of ping attempts in the No. of Pings field.
5. Enter the time between Ping send operations in milliseconds in the Ping Interval
field.
6. Click Start Test to begin the Ping operation. The Ping results will display in the
Results pane.
7. You can click Abort Test at any time during the test to stop the Ping operation.
8. Repeat steps 2 through 6 for each device you want to ping.
When done, click Clear Results to delete the Ping results in the Results pane.
Traceroute Utility
Traceroute allows you to map the network path from the SBG941 Configuration Manager
to a public host. Selecting Traceroute from the Select Utility drop-down list will present
alternate controls for the Traceroute utility.
1. Enter the IP address or Host Name of the computer you want to target for the
Traceroute operation in the Target field.
2. Enter the maximum number of hops that the Traceroute operation performs before
stopping in the Max Hops field.
3. Enter the data packet size in bytes in the Data Size field.
4. Set the base UDP port number used by Traceroute in the Base Port field. The default
is 33434. If a UDP port is not available, this field can be used to specify an unused
port range.
5 • Status Pages 26